(IA) Remove battery/cables right side

Remove the side covers using an 8mm socket driver or socket. There are two bolts on each side. Be sure and set the covers safely aside where they won't be scratched or damaged. HTP4-8-30 Odyssey Battery Kit Install www.happy-trail.com

The seat is held in place by one bolt on each side (10 mm). After removing bolts slide the seat rearward and then up to remove. HTP4-8-30 Odyssey Battery Kit Install www.happy-trail.com

If your bike is fitted with the Happy Trails PD Nerf System remove the two outside upper bolts (5 mm hex) and nuts (10 mm) and rotate the guard out of the way. HTP4-8-30 Odyssey Battery Kit Install www.happy-trail.com

Remove the two #2 Phillips screws holding the master cylinder reservoir cover. HTP4-8-30 Odyssey Battery Kit Install www.happy-trail.com

Loosen but do not remove the 6 mm hex clamp bolt joining the muffler and header pipe. It is located underneath and behind the master cylinder reservoir. HTP4-8-30 Odyssey Battery Kit Install www.happy-trail.com

Remove the bolt (12 mm) holding the header pipe strap to the frame. HTP4-8-30 Odyssey Battery Kit Install www.happy-trail.com

Loosen and remove the two 12 mm acorn nuts holding the exhaust header pipe flange to the engine. HTP4-8-30 Odyssey Battery Kit Install www.happy-trail.com

Coax and jiggle the pipe off the engine and rotate the pipe out of the muffler. It shouldn't be necessary to remove the pipe entirely. HTP4-8-30 Odyssey Battery Kit Install www.happy-trail.com

You should now be able to see and get at the bolt (10 mm) holding the negative cable to the starter. A 10 mm deep socket on a 1/4" drive ratchet is ideal for removing this bolt. HTP4-8-30 Odyssey Battery Kit Install www.happy-trail.com

This is what the cable attachment looks like with the pipe out of the way. If you are unable to access the bolt with the pipe in place simply remove it entirely. HTP4-8-30 Odyssey Battery Kit Install www.happy-trail.com

The OEM cable disconnected. Please note the bend in the cable end. When reinstalling the kit cable you'll want to ensure the bend is oriented in just the same way. HTP4-8-30 Odyssey Battery Kit Install www.happy-trail.com

Also when reinstalling jiggle the pipe into position. Begin tightening the two acorn nuts at the flange but also move to the middle of the pipe and reinstall the bolt holding the strap clamp for the muffler and pipe. Then return to the header and uniformly tighten the two acorn nuts. HTP4-8-30 Odyssey Battery Kit Install www.happy-trail.com